Cisco IE-5000 User Manual

475
Configuring SPAN and RSPAN
How to Configure SPAN and RSPAN
3. monitor session session_number source
{interface interface-id | vlan vlan-id} [, | -]
[both | rx | tx]
Specifies the SPAN session and the source port (monitored port).
session_number—The range is 1 to 68.
interface-id—Specifies the source port or source VLAN to monitor.
 source interface-id—Specifies the source port to monitor. Valid
interfaces include physical interfaces and port-channel logical
interfaces (port-channel port-channel-number). Valid
port-channel numbers are 1 to 10.
 vlan-id—Specifies the source VLAN to monitor. The range is 1 to
4096 (excluding the RSPAN VLAN).
Note: A single session can include multiple sources (ports or
VLANs), defined in a series of commands, but you cannot combine
source ports and source VLANs in one session.
(Optional) [, | -] Specify a series or range of interfaces. Enter a space
before and after the comma; enter a space before and after the
hyphen.
(Optional) Specify the direction of traffic to monitor. If you do not
specify a traffic direction, the SPAN monitors both sent and received
traffic.
 both—Monitors both received and sent traffic. This is the default.
 rx—Monitors received traffic.
 tx—Monitors sent traffic.
Note: You can use the monitor session session_number source
command multiple times to configure multiple source ports.
Command Purpose

Cisco IE-5000 Specifications

General

Model	IE-5000
Category	Industrial Ethernet Switch
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16, 000 entries
Ports	16 or 24 10/100/1000 ports
Uplink Ports	4 SFP ports
Operating Temperature	-40°C to 70°C
Power Supply	Dual redundant power supplies
Mounting	DIN rail
Management	Web GUI, CLI, SNMP
Input Voltage	24 VDC or 110/220 VAC
Layer	Layer 2/3
Jumbo Frame Support	Up to 9216 bytes