525
Configuring System Message Logging
Additional References
000019: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
Enabling the Logger: Example
This example shows how to enable the configuration-change logger and to set the number of entries in the log to 500.
Switch(config)# archive
Switch(config-archive)# log config
Switch(config-archive-log-cfg)# logging enable
Switch(config-archive-log-cfg)# logging size 500
Switch(config-archive-log-cfg)# end
Configuration Log Output: Example
This is an example of output for the configuration log:
Switch# show archive log config all
idx sess user@line Logged command
38 11 unknown user@vty3 |no aaa authorization config-commands
39 12 unknown user@vty3 |no aaa authorization network default group radius
40 12 unknown user@vty3 |no aaa accounting dot1x default start-stop group radius
41 13 unknown user@vty3 |no aaa accounting system default
42 14 temi@vty4 |interface GigabitEthernet4/0/1
43 14 temi@vty4 | switchport mode trunk
44 14 temi@vty4 | exit
45 16 temi@vty5 |interface FastEthernet5/0/1
46 16 temi@vty5 | switchport mode trunk
47 16 temi@vty5 | exit
Additional References
The following sections provide references related to switch administration:
To Next Page
Loading...
Need help?
General
