EasyManuals Logo

Cisco IE-5000 User Manual

Cisco IE-5000
1066 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
61
Performing Switch Setup Configuration
Information About Performing Switch Setup Configuration
Reload sequences occur immediately if your switch is set up to automatically bring up the system by using information
in the BOOT environment variable. Otherwise, these reload sequences occur after you enter the manual boot command
in bootloader configuration mode.
First Reload
The switch disables the boot fast feature and displays the following warning message:
“Reloading with boot fast feature disabled”
After the system message appears, the system saves the crash information and automatically resets itself for the next
reload cycle.
Second Reload
The boot loader performs its normal full memory test and FSCK check with LED status progress. If the memory and FSCK
tests are successful, the system performs additional POST tests and the results are displayed on the console.
The boot fast feature is reenabled after the system comes up successfully.
Switch Information Assignment
You can assign IP information through the switch setup program, through a DHCP server, or manually.
Use the switch setup program if you want to be prompted for specific IP information. With this program, you can also
configure a hostname and an enable secret password. The program gives you the option of assigning a Telnet password
(to provide security during remote management) and configuring your switch as a command or member switch of a
cluster or as a standalone switch. For more information about the setup program, see the Hardware Installation Guide
Hardware Technical Guide.
Use a DHCP server for centralized control and automatic assignment of IP information after the server is configured.
Note: If you are using DHCP, do not respond to any of the questions in the setup program until the switch receives the
dynamically assigned IP address and reads the configuration file.
If you are an experienced user familiar with the switch configuration steps, manually configure the switch. Otherwise,
use the setup program.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco IE-5000 and is the answer not in the manual?

Cisco IE-5000 Specifications

General IconGeneral
ModelIE-5000
CategoryIndustrial Ethernet Switch
Switching Capacity128 Gbps
Forwarding Rate95.2 Mpps
MAC Address Table Size16, 000 entries
Ports16 or 24 10/100/1000 ports
Uplink Ports4 SFP ports
Operating Temperature-40°C to 70°C
Power SupplyDual redundant power supplies
MountingDIN rail
ManagementWeb GUI, CLI, SNMP
Input Voltage24 VDC or 110/220 VAC
LayerLayer 2/3
Jumbo Frame SupportUp to 9216 bytes

Related product manuals