Cisco IE-5000 User Manual

702
Configuring IP Multicast Routing
Configuring IP Multicast Routing
BEFORE YOU BEGIN
 This command should only be configured on RP mapping agents.
 If you use more than one RP-mapping agent, you must configure the same filters on all mapping agents to avoid
inconsistencies in Auto-RP operations.
 An improperly configured ip pim rp-announce-filter command may result in RP announcements being ignored. In
addition, the ip pim rp-announce-filter command should only be configured on the mapping agent; if not, the
command will fail because non-mapping agents do not listen to group 224.0.1.39 and do not know how to distribute
the necessary group-to-RP mappings.

Cisco IE-5000 Specifications

General

Model	IE-5000
Category	Industrial Ethernet Switch
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16, 000 entries
Ports	16 or 24 10/100/1000 ports
Uplink Ports	4 SFP ports
Operating Temperature	-40°C to 70°C
Power Supply	Dual redundant power supplies
Mounting	DIN rail
Management	Web GUI, CLI, SNMP
Input Voltage	24 VDC or 110/220 VAC
Layer	Layer 2/3
Jumbo Frame Support	Up to 9216 bytes