Cisco IE-5000 User Manual

86
Configuring Cisco IOS Configuration Engine
Configuring Cisco IOS Agents
6. cns connect name [retries number]
[retry-interval seconds] [sleep seconds]
[timeout seconds]
Enters CNS connect configuration mode, specifies the name of
the CNS connect profile, and defines the profile parameters. The
switch uses the CNS connect profile to connect to
Configuration Engine.
 (Optional) retries number—Enters the number of connection
retries. The range is 1 to 30. The default is 3.
 (Optional) retry-interval seconds—Enters the interval
between successive connection attempts to the
Configuration Engine. The range is 1 to 40 seconds. The
default is 10 seconds.
 (Optional) sleep seconds—Enters the amount of time before
which the first connection attempt occurs. The range is 0 to
250 seconds. The default is 0.
 (Optional) timeout seconds—Enters the amount of time after
which the connection attempts end. The range is 10 to 2000
seconds. The default is 120.
7. discover {controller controller-type | dlci
[subinterface subinterface-number] |
interface [interface-type] | line line-type}
Specifies the interface parameters in the CNS connect profile.
 controller controller-type—Enters the controller type.
 dlci—Enters the active data-link connection identifiers
(DLCIs).
(Optional) subinterface subinterface-number—Specifies the
point-to-point subinterface number that is used to search
for active DLCIs.

interface [interface-type]—Enters the type of interface.
 line line-type—Enters the line type.
8. template name [ ... name] Specifies the list of CNS connect templates in the CNS connect
profile to be applied to the switch configuration. You can specify
more than one template.
9. Repeat Steps 7 to 8 to specify more interface parameters and
CNS connect templates in the CNS connect profile.
10. exit Returns to global configuration mode.
11. hostname name Enters the hostname for the switch.
12. ip route network-number (Optional) Establishes a static route to Configuration Engine
whose IP address is network-number.
Command Purpose

Cisco IE-5000 Specifications

General

Model	IE-5000
Category	Industrial Ethernet Switch
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16, 000 entries
Ports	16 or 24 10/100/1000 ports
Uplink Ports	4 SFP ports
Operating Temperature	-40°C to 70°C
Power Supply	Dual redundant power supplies
Mounting	DIN rail
Management	Web GUI, CLI, SNMP
Input Voltage	24 VDC or 110/220 VAC
Layer	Layer 2/3
Jumbo Frame Support	Up to 9216 bytes