Cisco IE-5000 User Manual

912
Configuring IP Unicast Routing
Configuring Protocol-Independent Features
DETAILED STEPS
Command Purpose
1. configure terminal Enter global configuration mode.
2. route-map map-tag [permit | deny] [sequence
number]
Define any route maps used to control
redistribution and enter route-map configuration
mode.
 map-tag—A meaningful name for the route
map. The redistribute router configuration
command uses this name to reference this
route map. Multiple route maps might share
the same map tag name.
 (Optional) If permit is specified and the match
criteria are met for this route map, the route is
redistributed as controlled by the set actions.
If deny is specified, the route is not
redistributed.
 sequence number (Optional)— Number that
indicates the position a new route map is to
have in the list of route maps already
configured with the same name.
3. match as-path path-list-number Match a BGP AS path access list.
4. match community-list community-list-number
[exact]
Match a BGP community list.
5. match ip address {access-list-number |
access-list-name} [...access-list-number |
...access-list-name]
Match a standard access list by specifying the
name or number. It can be an integer from 1 to
199.
6. match metric metric-value Match the specified route metric. The metric-value
can be an EIGRP metric with a specified value from
0 to 4294967295.
7. match ip next-hop {access-list-number |
access-list-name} [...access-list-number |
...access-list-name]
Match a next-hop router address passed by one of
the access lists specified (numbered from 1 to
199).
8. match tag tag value [...tag-value] Match the specified tag value in a list of one or
more route tag values. Each can be an integer from
0 to 4294967295.
9. match interface
type number [...type number] Match the specified next hop route out one of the
specified interfaces.
10. match ip route-source {access-list-number |
access-list-name} [...access-list-number |
...access-list-name]
Match the address specified by the specified
advertised access lists.
11. match route-type {local | internal | external
[type-1 | type-2]}
Match the specified route-type:
 local—Locally generated BGP routes.
 internal—OSPF intra-area and interarea routes
or EIGRP internal routes.
 external—OSPF external routes (Type 1 or
Type 2) or EIGRP external routes.

Cisco IE-5000 Specifications

General

Brand	Cisco
Model	IE-5000
Category	Switch
Language	English