Cisco IE-5000 User Manual

991
Cisco Systems, Inc. www.cisco.com
Ethernet CFM
Cisco Industrial Ethernet switches supports Ethernet CFM. Ethernet CFM is an end-to-end per-service-instance (per
VLAN) Ethernet layer OAM protocol that includes proactive connectivity monitoring, fault verification, and fault isolation.
End-to-end can be provider-edge-to-provider-edge (PE-to-PE) device or customer-edge-to-customer-edge
(CE-to-CE) device. Ethernet CFM, as specified by 802.1ag, is the standard for Layer 2 ping, Layer 2 traceroute, and
end-to-end connectivity check of the Ethernet network.
For complete command and configuration information for Ethernet CFM, see the Configuring Ethernet OAM, CFM, and
E-LMI chapter of the System Management guide at this URL:
http://www.cisco.com/c/en/us/td/docs/switches/connectedgrid/cg-switch-sw-master/software/configuration/guide/
sysmgmt/CGS_1000_Sysmgmt/sm_oam.html

Cisco IE-5000 Specifications

General

Model	IE-5000
Category	Industrial Ethernet Switch
Switching Capacity	128 Gbps
Forwarding Rate	95.2 Mpps
MAC Address Table Size	16, 000 entries
Ports	16 or 24 10/100/1000 ports
Uplink Ports	4 SFP ports
Operating Temperature	-40°C to 70°C
Power Supply	Dual redundant power supplies
Mounting	DIN rail
Management	Web GUI, CLI, SNMP
Input Voltage	24 VDC or 110/220 VAC
Layer	Layer 2/3
Jumbo Frame Support	Up to 9216 bytes