Cisco NCS 2000 series

Clear the VOA-HFAIL Alarm 432
VOA-LMDEG 432
Clear the VOA-LDEG Alarm 433
VOA-LFAIL 433
Clear the VOA-LFAIL Alarm 433
VOLT-MISM 434
Clear the VOLT-MISM Condition 434
WAITING-TO-START 434
WAN-SYNCLOSS 434
Clear the WAN-SYNCLOSS Condition 435
WKSWPR (2R, EQPT, ESCON, FC, GE, ISC, OTS) 435
WKSWPR (TRUNK) 435
WRK-PATH-RECOVERY-CHECK 436
Clear the WRK-PATH-RECOVERY-CHECK Alarm 436
Wait to Restore Condition 436
WTR (TRUNK) 437
WVL-DRIFT-CHAN-OFF 437
Clear the WVL-DRIFT-CHAN-OFF Condition 437
WVL-MISMATCH 438
Clear the WVL-MISMATCH alarm 438
WVL-UNLOCKED Alarm 439
DWDM Card LED Activity 439
DWDM Card LED Activity After Insertion 439
DWDM Card LED Activity During Reset 440
Traffic Card LED Activity 440
Typical Traffic Card LED Activity After Insertion 440
Typical Traffic Card LED Activity During Reset 440
Typical Card LED State After Successful Reset 441
Frequently Used Alarm Troubleshooting Procedures 441
Node and Ring Identification, Change, Visibility, and Termination 441
Identify a BLSR Ring Name or Node ID Number 441
Change a BLSR Ring Name 442
Change a BLSR Node ID Number 442
Verify Node Visibility for Other Nodes 443
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
xxxii
Contents