Cisco NCS 2000 series

Protection Switching, Lock Initiation, and Clearing 443
Initiate a 1+1 Protection Port Force Switch Command 443
Initiate a 1+1 Manual Switch Command 444
Initiate a 1:1 Card Switch Command 445
Clear a 1+1 Force or Manual Switch Command 445
Initiate a Lock-On Command 446
Initiate a Card or Port Lockout Command 447
Clear a Lock-On or Lockout Command 447
Initiate a Lockout on a BLSR Protect Span 448
Clear a BLSR External Switching Command 448
CTC Card Resetting and Switching 449
Reset a Card in CTC 449
Reset an Active Control Card and Activate the Standby Card 450
Physical Card Reseating, Resetting, and Replacement 451
Remove and Reinsert (Reseat) the Standby Control Card 451
Remove and Reinsert (Reseat) Any Card 452
Physically Replace a Card 453
Generic Signal and Circuit Procedures 454
Verify the Signal BER Threshold Level 454
Delete a Circuit 454
Verify or Create Node Section DCC Terminations 455
Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit 455
Verify or Create Node RS-DCC Terminations 456
Clear an STM-N Card XC Loopback Circuit 457
Air Filter and Fan Procedures 457
Inspect, Clean, and Replace the Reusable Air Filter 457
Remove and Reinsert a Fan-Tray Assembly 460
Replace the Fan-Tray Assembly 460
Interface Procedures 461
Replace the Alarm Interface Panel 461
Transient Conditions 465
CHAPTER 3
Transients Indexed By Alphabetical Entry 465
Trouble Notifications 468
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
xxxiii
Contents