EasyManuals Logo

Cisco SPA 501G Administration Guide

Cisco SPA 501G
298 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #110 background imageLoading...
Page #110 background image
Configuring SIP, SPCP, and NAT
Configuring SIP
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 99
4
Register Enables periodic registration with the proxy. This
parameter is ignored if a proxy is not specified.
Defaults to yes.
Make Call Without Reg Enables making outbound calls without successful
(dynamic) registration by the phone. If set to no, the dial
tone plays only when registration is successful.
Defaults to no.
Register Expires Defines how often the phone renews registration with
the proxy. If the proxy responds to a REGISTER with a
lower expires value, the phone renews registration
based on that lower value instead of the configured
value.
If registration fails with an “Expires too brief” error
response, the phone retries with the value specified in
the Min-Expires header of the error.
Defaults to 60 seconds.
Ans Call Without Reg If enabled, the user does not have to be registered with
the proxy to answer calls.
Defaults to no.
Use DNS SRV Enables DNS SRV lookup for the proxy and outbound
proxy.
Defaults to no.
DNS SRV Auto Prefix Enables the phone to automatically prepend the proxy or
outbound proxy name with _sip._udp when performing a
DNS SRV lookup on that name.
Defaults to no.
Proxy Fallback Intvl Sets the delay after which the phone retries from the
highest priority proxy (or outbound proxy) after it has
failed over to a lower priority server.
The phone should have the primary and backup proxy
server list via DNS SRV record lookup on the server
name. It needs to know proxy priority; otherwise, it does
not retry.
Defaults to 3600 seconds.
Parameter Description

Table of Contents

Other manuals for Cisco SPA 501G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SPA 501G and is the answer not in the manual?

Cisco SPA 501G Specifications

General IconGeneral
BrandCisco
ModelSPA 501G
CategoryIP Phone
LanguageEnglish

Related product manuals