Cisco SPA 501G

Cisco SPA 500 Series and Wireless IP Phone Field Reference
Ext Tab
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 261
B
Ext Tab
The Ext tabs vary by phone and depend on the number of extensions the phone
model supports.
This section describes the fields for the following Ext tab headings:
• General, page 243
• Share Line Appearance, page 262
• NAT Settings, page 263
• Network Settings, page 263
• SIP Settings, page 264
• Call Feature Settings, page 267
• Proxy and Registration, page 269
Shared Held Key List Softkeys that display when a call is on hold on a
shared line. See Customizing Phone Softkeys,
page 51 for more information.
PSK1 through PSK6 To configure a speed dial script, enter the following
in the PSK field:
fnc=sd;ext=
extensionname @$PROXY;vid= outbound
extnum
;nme= name
where fnc is the function of the key (speed dial), ext
(
extensionname ) is the extension being dialed, vid is
the extension on the calling phone from which the
outbound call is sent, and
name is the name of the
speed dial being configured.
To configure an XML script, enter the following in the
PSK field:
fnc=xml;url=http://
scriptURL.xml ;nme= scriptname
where fnc is the function of the key (an XML script),
scriptURL.xml is the URL where the script is located,
and
scriptname is the name of the script.
Parameter Description