Cisco SPA 501G Administration Guide

Customizing Cisco SPA and Wireless IP Phones
Enabling Call Features
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 49
3
STEP 4 Under Supplementary Services, in the Auto Answer Page field, choose yes.
STEP 5 Click Submit All Changes. The phone reboots.
Configuring Paging Groups
You can configure a phone as part of a paging group. Users can then direct pages
to specific groups of phones.
Limitations:
• A phone can be a listening member of no more than two paging groups.
• No more than five paging groups can be configured on a phone.
To configure a phone as part of a paging group:
STEP 1 Log in to the web administration interface for the phone.
STEP 2 Click Admin Login and advanced.
STEP 3 Click the Phone tab.
STEP 4 Under Multiple Paging Group Parameters, enter the paging commands into the
Group Paging Script field. The syntax is as follows:
pggrp=ip-address:port;[name=xxx;]num=xxx;[listen={yes|no}]];
Where:
• IP address: Multicast IP address of the phone that will listen for and receive
pages.
• port: Port on which to page; you must use different ports for each paging
group. All phones in the same paging group must use the same port
number.
• name (optional): The name of the paging group.
• num: The number users will dial to access the paging group; must be unique
to the group.
• listen: If the phone being configured is a listening member of the page
group. A phone can be a listening member of a maximum of two groups. If
no value is entered, the default is to not listen as a member of this group.

Cisco SPA 501G Specifications

General

Brand	Cisco
Model	SPA 501G
Category	IP Phone
Language	English