A
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 191
Creating an LED Script
LED Script
The LED script describes the color and blinking pattern of a Line Key LED. Each
script contains a number of fields separated by a semicolon(;). White spaces are
ignored. Each field has the syntax <field-name> = <field-value>. The allowed
field-name and corresponding field-values are listed below:
c=o|r|g|a
This field sets the color of the LED. The 4 choices are:
• o = off
• r = red
• g = green
• a = amber (orange)
p=n[b]|s[b]|f[b]|d[b]|u[d]
This field sets the blinking pattern of the LED. The 4 choices are:
• nb = no blink (steady on or off)
• sb = slow blink (1s on and 1s off)
• fb = fast blink (100ms on and 100ms off)
• ud = user-defined (according to the contents of the u field)
u=on/off/on/off/etc.
This is a user-defined blinking pattern used only when p = ud. It consists of up to 4
pairs of on/off duration in seconds with up to 2 decimal places; each value is
separated by a forward slash (/).
To Next Page
Loading...
Need help?
General
