EasyManuals Logo

Cisco SPA 501G Administration Guide

Cisco SPA 501G
298 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #113 background imageLoading...
Page #113 background image
Configuring SIP, SPCP, and NAT
Configuring SPCP on the Cisco SPA 50XG
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 102
4
Configuring SPCP on the Cisco SPA 50XG
The Cisco SPA 50XG can be used as part of a Cisco Unified Communications
System. This system uses SPCP (also called SCCP) for call control features.
To configure SPCP on the Cisco SPA 50XG:
STEP 1 Log in to the web administration interface.
STEP 2 Click Admin Login and advanced.
STEP 3 Click the System tab.
STEP 4 Under System Configuration, in the Signaling Protocol field, choose SCCP.
STEP 5 (Optional) To configure the phone to automatically detect the protocol being used
on the network to which it is connected, in the SPCP Auto-detect field, choose
yes.
STEP 6 Click Submit All Changes.
NOTE For the Cisco SPA501G, can be configured using the IVR. See the “Using IVR on
the Cisco SPA 501G IP Phone” section on page 17.
Network Address Translation (NAT) and Cisco IP Phones
NAT is a function that allows multiple devices to share the same public, routable, IP
address to establish connections over the Internet. NAT is present in many
broadband access devices to translate public and private IP addresses. To enable
VoIP to co-exist with NAT, some form of NAT traversal is required.

Table of Contents

Other manuals for Cisco SPA 501G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SPA 501G and is the answer not in the manual?

Cisco SPA 501G Specifications

General IconGeneral
BrandCisco
ModelSPA 501G
CategoryIP Phone
LanguageEnglish

Related product manuals