Cisco SPA 501G Administration Guide

Configuring Regional Parameters and Supplementary Services
Advanced Scripting for Cadences, Call Progress Tones, and Ring Tones
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 148
7
A RingScript is a mini-script that describes a ring tone. The syntax follows:
n=ring-tone-name;w=waveform-id-or-path;c=cadence-id;b=break-
time;t=total-time
ring-tone-name is a name to identify this ring tone specification. This name will
appear on the Ring Tone menu of the phone. The same name can be used in a
SIP Alert-Info header in an inbound INVITE request to tell the phone to play the
corresponding ring tone specification. Because of this, the name should
contain characters allowed in a URL only.
Waveform-id is the index of the desired waveform to use in this ring tone
specification. There are 4 built-in waveforms:
- 1 = A classic phone with mechanical bell
- 2 = Typical phone ring
- 3 = A classic ring tone
- 4 = A wide-band frequency sweep signal
This field can also be a network path (url) to download a ring tone data file from a
server on-the-fly. In this case, the syntax of the field is
w=[tftp://]hostname[:port]/path.
cadence-id is the index of the desired cadence to play the given waveform. 8
cadences (1–8) as defined in <Cadence 1> through <Cadence 8>. Cadence-id
can be 0 If w=3,4, or an url. Setting c=0 implies the on-time is the natural length
of the ring tone file.
break-time specifies the number of seconds to break between two bursts of
ring tone, such as b=2.5
total-time specifies the total number of seconds to play the ring tone before it
times out
Example 1: SIT Tone
n=Classic-1,w=3;c=1
n=Simple-1,w=2;c=1

Cisco SPA 501G Specifications

General

Brand	Cisco
Model	SPA 501G
Category	IP Phone
Language	English