Provisioning Basics
Upgrading, Resyncing, and Rebooting Phones
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 139
6
Resyncing a Phone
You can resync an IP phone to a specific remote profile. The configuration of the
phone you resync will match the configuration of the remote phone. The phone
can be configured to resync its internal configuration state to a remote profile
periodically and on power up.
NOTE The phone resyncs only when it is idle.
Use the following syntax to resync a phone’s profile to a profile on a TFTP, HTTP, or
HTTPS server:
http://phone-ip-addr/admin/resync?protocol://server-
name[:port]/profile-pathname
• Parameter following resync? defaults to the Profile Rule setting on the web
server Provisioning page.
• Protocol defaults to TFTP.
• Server-name defaults to the host requesting the URL.
Log_Upgrade_Success_Msg Syslog message issued after a firmware upgrade
attempt completes successfully.
The default is
$PN $MAC -- Successful upgrade $SCHEME://
$SERVIP:$PORT$PATH -- $ERR
Log_Upgrade_Failure_Msg Syslog message issued after a failed firmware
upgrade attempt.
The default is
$PN $MAC -- Upgrade failed: $ERR.
License Keys This field is empty.
Parameter Description
To Next Page
Loading...
