Cisco SPA 501G Administration Guide

Getting Started
Using the Web Administration User Interface
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 14
1
Understanding Basic and Advanced Views
These views are similar, but advanced view shows more options on each web
page. To see all available options for your login, use the
advanced view.
Using the Web Administration Tabs
Each tab contains different parameters. Some tasks require you to set parameters
in different tabs.
For field reference about each parameter available on the web UI, see
Appendix B, “Cisco SPA 500 Series and Wireless IP Phone Field Reference.”
Roadmap to Web UI Features
The following tables provide a roadmap to features available on the web UI.
To perform these tasks... On the web UI, click the ...
View phone, extension, and line/call information,
including:
• DHCP, current IP address, DNS addresses
• Software and hardware versions
• Broadcast, RTP, and SIP information
• Registration state
• Packets sent, received, lost, and other
information
Info tab
See “Viewing Phone
Information” section on
page 17.
Configure system-level parameters, including
network and debug parameters. To:
• Enable the web UI and web administrator
access
• Set the Internet connection type to DHCP
• Configure the syslog and debug servers
• Enable VLAN and CDP
System tab
See Chapter 5, “Configuring
Security, Quality, and Network
Features.”

Cisco SPA 501G Specifications

General

Brand	Cisco
Model	SPA 501G
Category	IP Phone
Language	English