Provisioning Basics
Sample Configuration File
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 136
6
General Purpose Parameters
These are configured in the General Purpose Parameters section of the
Provisioning tab. These parameters can be used as variables in provisioning and
upgrade rules. They are referenced by prepending the variable name with a ‘$’
character, such as $GPP_A.
You can optionally Require Admin Password to Reset Unit to Factory Defaults (see
last line of sample config file).
Sample Configuration File
Following is a sample configuration file:
Set_Local_Date_(mm/dd) "" ;
Set_Local_Time_(HH/mm) "" ;
Time_Zone "GMT-07:00" ; # options: GMT-12:00/GMT-11:00/GMT-10:00/GMT-09:00/
GMT-08:00/GMT-07:00/GMT-06:00/GMT-05:00/GMT-04:00/GMT-03:30/GMT-03:00/GMT-
02:00/GMT-01:00/GMT/GMT+01:00/GMT+02:00/GMT+03:00/GMT+03:30/GMT+04:00/
GMT+05:00/GMT+05:30/GMT+05:45/GMT+06:00/GMT+06:30/GMT+07:00/GMT+08:00/
GMT+09:00/GMT+09:30/GMT+10:00/GMT+11:00/GMT+12:00/GMT+13:00
FXS_Port_Impedance "600" ; # options: 600/900/600+2.16uF/900+2.16uF/
270+750||150nF/220+820||120nF/220+820||115nF/370+620||310nF
FXS_Port_Input_Gain "-3" ;
FXS_Port_Output_Gain "-3" ;
DTMF_Playback_Level "-16" ;
DTMF_Playback_Length ".1" ;
Detect_ABCD "Yes" ;
Playback_ABCD "Yes" ;
Caller_ID_Method "Bellcore(N.Amer,China)" ; # options:
Bellcore(N.Amer,China)/DTMF(Finland,Sweden)/DTMF(Denmark)/ETSI DTMF/ETSI
DTMF With PR/ETSI DTMF After Ring/ETSI FSK/ETSI FSK With PR(UK)
FXS_Port_Power_Limit "3" ; # options: 1/2/3/4/5/6/7/8
Protect_IVR_FactoryReset “No” ;
NOTE You can optionally require an admin password to reset the phone to factory
defaults by setting the last line parameter to “yes.”
If you are a service provider with a password, see the
Cisco Small Business IP
Telephony Devices Provisioning Guide.
To Next Page
Loading...
Need help?
General
