Cisco SPA 501G Administration Guide

Cisco SPA 500 Series and Wireless IP Phone Field Reference
System Tab
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 207
B
VLAN Settings
NOTE Not applicable to the WIP310.
Enable Bonjour Enable Bonjour networking that is used by Office
Manager and Cisco Configuration Assistant to discover
the Cisco IP phones. Choose yes to enable or no to
disable.
Parameter Description
Parameter Description
Enable VLAN Choose Ye s to enable VLAN. Choose no to disable.
Enable CDP
Enable CDP only if you are using a switch that has
Cisco Discovery Protocol. CDP is negotiation based
and determines which VLAN the IP phone resides in.
VLAN ID If you use a VLAN without CDP (VLAN enabled and
CDP disabled), enter a
VLAN ID for the IP phone. Note
that only voice packets are tagged with the VLAN ID.
Enable PC Port VLAN Tagging Enables VLAN and priority tagging on the phone data
port (802.1p/q). This feature facilities tagging of the
VLAN ID (802.1Q) and priority bits (802.1p) of the traffic
coming from the PC port of the IP phone.
Defaults to No. Choose Yes to enable the tagging
algorithm.
PC Port VLAN Highest Priority 0-7 (default 0). The priority applied to all frames,
tagged and untagged. The phone modifies the frame
priority only if the incoming frame priority is higher than
this value.
PC Port VLAN ID 0-4095 (default 0). Value of the VLAN ID. The phone
tags all the untagged frames coming from the PC (it will
not tag frames with an existing tag).

Cisco SPA 501G Specifications

General

Brand	Cisco
Model	SPA 501G
Category	IP Phone
Language	English