Cisco SPA 501G Administration Guide

Configuring Security, Quality, and Network Features
Setting Optional Network Parameters
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 124
5
Setting Optional Network Parameters
STEP 1 Log in to the web administration interface.
STEP 2 Click Admin Login and advanced.
STEP 3 Click the System tab.
STEP 4 Configure the following fields:
Parameter Description
Host Name The host name of the phone.
Domain The network domain of the phone. However, if using
LDAP, see Configuring Lightweight Directory Access
Protocol (LDAP) for the Cisco SPA 500 Series,
page 68.
Primary DNS DNS server used by the phone in addition to DHCP
supplied DNS servers if DHCP is enabled; when DHCP
is disabled, this is the primary DNS server.
Defaults to 0.0.0.0.
However, if using LDAP, see Configuring Lightweight
Directory Access Protocol (LDAP) for the Cisco SPA
500 Series, page 68.
Secondary DNS DNS server used by the phone in addition to DHCP
supplied DNS servers if DHCP is enabled; when DHCP
is disabled, this is the secondary DNS server.
Defaults to 0.0.0.0.
DNS Server Order Specifies the method for selecting the DNS server. The
options are Manual, Manual/DHCP, and DHCP/Manual.
DNS Query Mode Do parallel or sequential DNS Query. With parallel DNS
query mode, the phone sends the same request to all
the DNS servers at the same time when doing a DNS
lookup, the first incoming reply is accepted by the
phone.
Defaults to parallel.
Not available on WIP310.

Cisco SPA 501G Specifications

General

Brand	Cisco
Model	SPA 501G
Category	IP Phone
Language	English