EasyManuals Logo

Cisco SPA 501G Administration Guide

Cisco SPA 501G
298 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #133 background imageLoading...
Page #133 background image
Configuring Security, Quality, and Network Features
Configuring Domain and Internet Settings
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 122
5
NOTE PPPoE is not applicable to WIP310.
STEP 5 Click Submit All Changes.
NOTE For the SPA501G, can be configured using the IVR. See the “Using IVR on the
Cisco SPA 501G IP Phone” section on page 17.
Setting a Static IP Address
If you configured Static IP as the internet connection type:
STEP 1 Log in to the web administration interface.
STEP 2 Click Admin Login and advanced.
STEP 3 Click the System tab.
STEP 4 Configure the following fields:
Static IP Address—Enter the static IP address of the phone.
Netmask—Enter the subnet mask of the phone.
Gateway—Enter the IP address of the gateway.
For the SPA 525G, you also have the following fields available:
LAN MTU—LAN Maximum Transmission Unit size. Default value: 1500.
Duplex Mode—Choose one of the following to configure the speed/duplex
for the phone’s Ethernet ports:
- Auto
- 10MBps/Duplex
- 10MBps/Half
- 100Mbps/Duplex
- 100MBps/Half

Table of Contents

Other manuals for Cisco SPA 501G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SPA 501G and is the answer not in the manual?

Cisco SPA 501G Specifications

General IconGeneral
BrandCisco
ModelSPA 501G
CategoryIP Phone
LanguageEnglish

Related product manuals