Cisco SPA 501G Administration Guide

Configuring the Cisco SPA 500S Attendant Console
Setting Up the Cisco SPA 500S Attendant Console
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 183
9
This is entered in the file sip.conf:
[3500]
type=friend
secret=3500
callerid="spa3500"<3500>
nat=no
context=home
mailbox=3500
Subscribecontext=home
...
...
Configuring the Cisco SPA 500S
Complete the configuration required for the extensions on your IP PBX and obtain
the following information:
• IP PBX IP address or other hostname
• Phone extension numbers
To configure the Cisco SPA 500S:
NOTE Steps 1 through 4 are only required when the Server Type field is set to SPA9000.
These steps are not required for other server types such as BroadSoft and
Asterisk.
STEP 1 Connect to the web UI for the phone to which the Cisco SPA 500S is connected.
STEP 2 Click Admin/Advanced on the web UI page.
STEP 3 Click the SIP tab.
STEP 4 Select yes from the CTI Enable drop-down list.
STEP 5 Click the Attendant Console tab.
STEP 6 Select yes from the Unit 1 Enable drop-down list. If you have installed two Cisco
SPA 500S units, also select yes from the
Unit 2 Enable drop-down list.

Cisco SPA 501G Specifications

General

Brand	Cisco
Model	SPA 501G
Category	IP Phone
Language	English