Cisco SPA 501G Administration Guide

Getting Started
Using the Web Administration User Interface
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide 12
1
NOTE If your service provider disabled access to the web UI, you must contact the
service provider.
If you have trouble accessing the web interface, perform the following steps:
Cisco SPA 502G, Cisco SPA 504G, Cisco SPA 508G, Cisco SPA 509G:
STEP 1 Press the Setup button on the phone.
STEP 2 Select Network.
STEP 3 Scroll to Enable Web Server and make sure that it is set to Ye s. If not, press the
Edit soft key and press y/n soft key to set it to Yes .
STEP 4 Press OK, then press Save.
Cisco SPA 501G:
STEP 1 Press the Setup button on the phone.
STEP 2 In the IVR menu, enter 7932.
STEP 3 Press 1 to enable the web server, then press #.
STEP 4 To s a v e , p r e s s 1; to review, press 2; to re-enter, press 3; to exit, press *.
WIP310:
STEP 1 In the Home screen, press the Select button to choose Settings.
STEP 2 Press the Select button again to reach the Settings menu.
STEP 3 Scroll to highlight Misc Settings and press the Select button.
STEP 4 Press the left arrow to ensure that Enable Web Server is set to On.
STEP 5 Press the Select button to save this setting.

Cisco SPA 501G Specifications

General

Brand	Cisco
Model	SPA 501G
Category	IP Phone
Language	English