User Manual: WaveLinx Lite (4.0)
168
e a Device in a Standalone Area
When replacing a device in a standalone area simply provision the new device, assigning it to the standalone area as instructed in “Standalone
Area Provisioning” on page 68. In WaveLinx Lite 4.0 (as a precaution to prevent inadvertent device deletion) it is not possible to delete a device
that is not communicating from a standalone area.
Factory Reset a Device
If a device is not responding to the mobile application or is exhibiting provisioned device behavior but not able to be located in the mobile
application, the device may be manually factory reset.
A manual factory reset returns the device to its out-of-the-box behavior.
For specific details on performing the manual device factory reset, refer to that specific device’s reference sheet in the section starting on page
9.
To Next Page
Loading...
