(1) Unloader
1. Store and fix the unloader to its
support.
2. Check that the tank drive belt is
tight and the tank mounting bolt is
tightened rmly.
PREPARATION OF EACH PART BEFORE WORK
INSPECTING TANK
cf1O702a
(1) Tank Mounting Bolt
(2) Tank Driving Belt
CAUTIONS DURING WORK
1. Never operate the threshing clutch
lever while the engine is running
at a low speed. The threshing unit
can be clogged or damaged.
2. It is hard to work on a small eld
or on the edge of a eld. For your
safety, work with care at a low
speed.
3. When switching between the cutter
and dropper operations, stop the
threshing unit in advance.
4. When the dust-proof cover on the
engine gets dusty during work,
clean it as necessary. If keeping
working with the dusty dust-roof
cover, the engine can be overheat-
ed.
To Next Page
Loading...