sYMpToM Cause
inspeCTion
iTeM
soluTion
3. The reaping unit
does not cut
crops but rather
pushes them
aside.
Cutting blades are dull Cutting blade
S
top operation temporarily, stop the engine and adjust the gap.
Stop operation temporarily, stop the engine and replace it.
The working speed is
too fast.
Main shift lever
R
ange shift lever
Adjust the working speed according to crop and eld conditions.
4. An excessive
amount of stems
are reaped off
while reaping
crops.
Crops are too light or
short.
R
eel position
Stop operation temporarily, place the reaping clutch lever in the
OFF position and lower the reel close to the auger. (Release the
reel anti-drop stopper.)
sYMpToM Cause
inspeCTion
iTeM
soluTion
1. There is a lot of
separated abnor-
mal grains.
The threshing teeth
are worn.
Threshing teeth
S
top operation temporarily, stop the engine and adjust or replace
it.
The threshing cylinder
concave is clogged.
Threshing cylin-
der concave
S
top operation temporarily, stop the engine and clean it.
The engine speed is
too low.
Throttle lever I
ncrease the engine speed.
The working speed is
too fast.
Main and range
shift levers
Adjust the working speed according to crop and eld conditions.
2. Threshing perfor-
mance is poor.
The threshing teeth
are worn or deformed.
Threshing teeth
S
top operation temporarily, stop the engine and adjust or replace
it.
TroubleshooTing for Threshing uniT
To Next Page
Loading...
