Drain coolant according to the follow-
ing instructions (coolant completely
cooled down):
1. Open the radiator cap.
2. Open the drain plug.
3. With the drain plug removed, place a
sign, "No water," on the radiator cap.
(1) Drain Plug (2) Radiator Cap
CF1O901B
1. Install the battery again. Check
that the battery is fully charged be-
fore installing it.
2. Check the fan belt tension.
3. Check all uid levels. (Engine oil,
transmission/hydraulic oil, engine
coolant)
4. Remove grease from the exposed
cylinder rod.
5. Apply grease to the lubrication
points.
6. Depress the clutch pedal and
undo the latch hook.
7. Get onto the combine and start the
engine.
8. Check if the instrument panel and
all parts operate correctly while
running the engine for a few min-
utes.
9. Drive the combine outside and
check if it is operating properly.
Park the combine outside and idle
engine for at least 5 minutes. Stop
the engine and visually inspect the
USING COMBINE AFTER LONG-TERM STORAGE
combine. Check if there is leak-
age.
10. Start the engine, release the
parking brake, and check the
brake condition by depressing
the brake pedal. Adjust the free
play of the brake pedals if neces-
sary.
11. Stop the engine and check for
leakage. Repair any part as re-
quired.
If the battery is not to be re-
moved, disconnect the nega-
tive battery cable at least. The
wiring can be gnawed by ro-
dents, leading to a re.
•
CAUTION
To Next Page
Loading...
