(1) Engine Oil Filter Cartridge
REPLACING ENGINE OIL FILTER CARTRIDGE
1. Remove the engine oil filter car-
tridge.
For a new cartridge, apply a thin
film of oil to its O-ring before in-
stalling it.
2. When the cartridge is replaced, the
engine oil level is decreased for
the amount of oil in the cartridge.
Add oil to the indication mark of
the oil gauge, run the engine for 5
minutes and check each section.
Then, stop the engine and check
the oil level again.
3. Replace the engine oil filter car-
tridge after initial 50 hours of use
and then every 200 hours.
CF1O825A
1. Remove the HST oil lter.
2. Install a new cartridge with the
O-ring applied with oil slightly.
3. When installing the HST oil filter,
turn it with a hand until it is seated
onto the mounting surface. Then,
rotate it a half turn further.
4. After replacing hydraulic oil and
lter, run the engine at the lowest
speed with the vehicle stopped for
a few minutes (for oil supply).
(1) Hst Oil Filter
HST OIL FILTER
To Next Page
Loading...
