(1) Reaping / Threshing Clutch Lever
1. Stop the machine in level ground
and lower the reaping unit.
2. Set the reaping/threshing clutch
lever in the OFF position.
3. Apply the parking brake, idle the
engine for 2 to 3 minutes, and set
the main switch in the OFF posi-
tion.
4. Remove the key from the main
switch and store it separately.
STOPPING ENGINE
cf1O604a
11. If the engine cannot be started
due to the discharged battery,
charge or replace the battery. If
this action cannot be performed
immediately, connect the battery
to another intact battery of an-
other vehicle with jump cables to
start the engine.
(1) Main Switch (2) Horn Switch
(A) STOP (C) ON
(B) Preheat (D) Start
9. In cold weather, place the main
switch in the PREHEAT position
to preheat the engine for 5 to 10
minutes before placing the main
switch in the START position to
start the engine.
10. If the vehicle runs out of fuel so
the engine is stopped during
driving, start the engine again
according to the following proce-
dure:
- Set the main shift lever in the OFF
position.
-
Place the threshing clutch lever
and reaping clutch lever in the
O
FF position.
- Add fuel into the fuel tank.
- After performing the Steps 1
through 4 above, cycle the main
s
witch between the ON position
and the START position 2 to 3
times.
Place the main switch in the ON
position and discharge exhaust
gas for 30 seconds.
•
NOTE
cf1O619a
To Next Page
Loading...
