When installing the unloader auger
shaft assembly 1, its boss 4 part
marked as (bottom) should face down
and should be 90° behind the blade
direction of the tank auger.
d85O891A
(1) Unloader Auger Shaft Assembly 1
(2) Tank Auger Assembly (End)
INSTALLING TANK AUGER AS-
SEMBLY AND UNLOADER AUGER
SHAFT ASSEMBLY 1
3. Remove the tank side cover.
(1) Tank Side Cover
OPENING GRAIN TANK
1. If there are grains in the tank, empty the
tank according to the instructions speci-
ed in the section "Discharging grains."
2. Store and x the unloader to its sup-
port.
(1) Unloader (2) Unloader Support
Make sure to open the grain
tank only when it is empty.
Set the shift levers to the neu-
tral position and the reaping
and threshing clutch levers to
the "
Disengage" position.
•
•
CAUTION
CF1O804A
Incorrect installation can re-
sult in interference and dam-
age of the auger and abnormal
operation of the tank auger.
•
CAUTION
To Next Page
Loading...
