ADJUSTING POWER BRAKE LEVER
(1) Clutch Lever (2) Brake Bolt
(A) Clearance
1. When installing the clutch cylinder,
set it parallel and symmetrical to
the center line of the transmission
case.
2. Apply LOCTITE to the mounting
bolt (M8) of the side clutch arm be-
fore installing it (tightening torque:
190 - 330 kg·cm).
3. Adjust the clearance A between
the brake bolt and side clutch lever
to 2 mm (±0.5mm). Then, tighten
the lock nut rmly.
d85O851A
ADJUSTING CRAWLER TENSION
(1) Front Wheel (2) Tension Bolt
(3) Mounting Nut (A) 13 - 18 mm
1. Unscrew the mounting nut of the ten-
sion bolt and tighten the tension bolt.
2. Lift the rear section of the frame
with a jack. Then, set the distance
between the second front wheel and
crawler to 13 to 18 mm.
3. Check that the both crawlers have
the same tension.
Distance between 2nd front wheel and crawler
Within 13 - 18 mm
Standard for clearance
A between brake bolt tip
and side clutch lever
2.0±0.5mm
Tightening torque for
mounting nut
260±30kgf·cm
CF1O817A
4. Inspection during driving: Engage
the side clutch firmly with the
clutch cylinder in the 1st stroke
(15.5 mm) condition.
To Next Page
Loading...
