Daedong DSF75GT - Reaping and turning method in the field

7
-
9
HARVESTDS
F75GT
7
-
8
7
-
9
HARVESTDS
F75GT
7
-
8
7. Place the reaping clutch lever in
the Engage position. Then, push
the main shift lever into the For-
ward driving position to start reap-
ing.
(1) Main Shift Lever
(2) Reaping Clutch Lever
(A) Engage (B) Forward Driving
1
A
1
22
A
BB
cf1O740a
8. After reaping, check the separa-
tion quality and threshed crops.
A
djust components if necessary.
9. After reaping, set the reaping
clutch lever in the disengaged po-
sition and conrm that every grain
is fed into the threshing cylinder
or grain tank before moving the
threshing clutch lever to the disen-
gaged position.
111
22
AA
A
A
cf1O751a
When the reaping unit (auger
or feeding unit) is clogged,
move the reaping clutch lever
to the OFF position immedi-
ately to pause reaping. Oth-
erwise, the reaping drive belt
may spin and may not feed
crops to the threshing unit, re-
sulting in belt damage.
•
IMPORTANT
REAPING AND TURNING
METHOD IN THE FIELD
(1) Field (2) Crops
(A) Reaping Direction
Place the range shift lever in the
Low speed position when reaping
in the following conditions:
Making a rst turn during reaping
after entering the eld
Sp
litting a large field in half for
efcient reaping operation
Reaping in a small eld or at the
corner of the eld
•
•
•
NOTE
CF100(DSF75GT)_콤바인_영문판_07.indd 8 2017-07-03 오후 2:33:29