FOR EXCESSIVE GRAIN DAMAGE
Decrease the engine speed down
to 2000 RPM or lower the discharge
amount control plate.
Press the unloader valve activation
lever on the lower section of the con-
t
rol panel and press the Up section
of the unloader valve to check if the
unloader is lifted.
IF UNLOADER CANNOT BE LIFTED
(1) Mounting Bolt (2 Pices For Front And Rear)
(A) Increase (Discharge Position)
(B) Decrease (C) Standard
ADJUSTING GRAIN DISCHARGE AMOUNT
Unscrew the mounting bolts from the
discharge amount adjusting plate on
the front, back and side of the tank.
Then, move the bolt to the desired
position to adjust the grain discharge
amount.
1. The standard position is the center
of the long hole.
2. If grains are not conveyed properly
or it takes more than 5 minutes to
empty the grain tank, move the
bolt (adjusting plate) to the upper
position.
3. For weak crops, move the bolt (ad-
justing plate) to the lower position.
Make sure to stop the engine
in advance.
•
CAUTION
To Next Page
Loading...
