sYMpToM Cause inspeCTion iTeM soluTion
6. The No. 2 auger
is clogged.
Crops are too wet. Crop S
top operation and reap crops after they are dried enough.
The engine speed
is too low.
Throttle lever I
ncrease the engine speed.
The No. 2 auger is
overloaded.
S
ieve case auxiliary plate Stop operation, stop the engine and adjust it forward.
Chaff control lever
S
top operation, stop the engine and adjust the chaff control
lever to the Open position.
Net
Stop operation, stop the engine and replace the net with
another net that has 23.5 mm meshes.
B
lower control slide
Stop operation temporarily, stop the engine and adjust it to
the Close (low) position.
E
ach part of the
sieve case is not
properly adjusted.
S
ieve case auxiliary plate Stop operation, stop the engine and adjust it forward.
Chaff control lever
S
top operation, stop the engine and adjust the chaff control
lever to the Open position.
Net
Stop operation, stop the engine and replace the net with
another net that has 23.5 mm meshes.
Dust discharge control
plate
S
top operation, stop the engine and adjust it downward.
To Next Page
Loading...
