DAELIM DAYSTAR - Page 133

13-6
Front Wheel/Front Fork/Steering
● Tighten the forward screws first, then tighten
the rear screws.
● After installing the brake hose, kill switch
cable, winker switch code and chock cable into
the cable guide, tighten the guide.
Inspection
● Inspect the front axle for bent.
● Install the front axle into V-block, and measure
it using a dial gauge.
Service Limit: Over 0.2mm
Front Wheel
Removal
● Loosen the axle nut.
● Raise and support the motorcycle using a jack.
Remove the screw from the speedometer cable.
Remove the axle nut, front axle, and front
wheel, and right side collar.
• Do not operate the front brake lever after
removing the front wheel.
NOTE
Screw
Screw
Screw
Screw
Screw
ScrewScrew
Screw
Screw
Screw
Screw
Screw
Screw
Cable Guide
Cable Guide
Cable Guide
Cable Guide
Cable Guide
Cable GuideCable Guide
Cable Guide
Cable Guide
Cable Guide
Cable Guide
Cable Guide
Cable Guide
Screw
Screw
Screw
Screw
Screw
ScrewScrew
Screw
Screw
Screw
Screw
Screw
Screw
Speedometer Cable
Speedometer Cable
Speedometer Cable
Speedometer Cable
Speedometer Cable
Speedometer CableSpeedometer Cable
Speedometer Cable
Speedometer Cable
Speedometer Cable
Speedometer Cable
Speedometer Cable
Speedometer Cable