DAELIM DAYSTAR - Page 134

13-7
Front Wheel/Front Fork/Steering
● Check the rim runout by placing the wheel in a
truing stand. Spin the wheel slowly and read
the runout using a dial indicator.
Service Limit:
Radial Runout: 2.0mm(0.08in)
Axial Runout: 2.0mm(0.08in)
Wheel Bearing Inspection
● Turn the inner race of each bearing with your
finger. The bearings should turn smoothly and
quietly. Also check that the bearing outer race
fits tightly in the hub. Remove and discard the
bearings if the races do not turn smoothly,
quietly, or if they fit loosely in the hub.
• Replace hub bearings in pairs.
Removal
● Remove the speedometer gear box, dust seal,
speedometer gear retainer.
● Remove the right side collar.
NOTE
Speedometer Grar Retainer
Speedometer Grar Retainer
Speedometer Grar Retainer
Speedometer Grar Retainer
Speedometer Grar Retainer
Speedometer Grar RetainerSpeedometer Grar Retainer
Speedometer Grar Retainer
Speedometer Grar Retainer
Speedometer Grar Retainer
Speedometer Grar Retainer
Speedometer Grar Retainer
Speedometer Grar Retainer
R. Side Collar
R. Side Collar
R. Side Collar
R. Side Collar
R. Side Collar
R. Side CollarR. Side Collar
R. Side Collar
R. Side Collar
R. Side Collar
R. Side Collar
R. Side Collar
R. Side Collar
Speedometer Grar Box
Speedometer Grar Box
Speedometer Grar Box
Speedometer Grar Box
Speedometer Grar Box
Speedometer Grar BoxSpeedometer Grar Box
Speedometer Grar Box
Speedometer Grar Box
Speedometer Grar Box
Speedometer Grar Box
Speedometer Grar Box
Speedometer Grar Box