Chapter 9 Assistant Operation Functions
110 BECS-A88/C88 computerized embroidery machine owner’s manual
Click
The system moves the frame to the design’s start point.
9-2
Saving the Start Point
If the origin point of the frame is already set (refer to “Setting Frame Protection
when Power-off”, Chapter Ten), the machine can save the start point of the current
design at the embroidery preparation status or before embroidering.
Move the frame to the start point.
Click in the main screen to enter the assistant operation screen.
Click “Save the design’s start point”.
A prompt window will pop up.
Click to save the current frame position as the design’s start point.
Click
to cancel the above operation.
To Next Page
Loading...
Need help?
General
