Chapter 5 Setting General Parameters
64 BECS-A88/C88 computerized embroidery machine owner’s manual
close to 100 degree. The value can be set between 0 and 30.
“Main Motor Para.” is to adjust cooperation between main shaft motor and
machinery parts. The parameter value can be set between 0 and 30, and set as 0 in
most situations. When during braking the main shaft vibrate without moving or
rotate in the reverse direction, the user can increase the parameter value.
After adjusting these parameters, the user can click the task swift key on the panel
to return to the main screen. Click
and , to check the effects of the
parameter adjustment. If the user is not satisfied with the effects, he can press the
swift key on the panel to return to the parameter setting screen, where he can
adjust the parameter setting again. Close the parameter setting screen in the end.
5.2.4
Forbidding Design Output
The function is to forbid copying the designs in memory (into the disk). If the
machine administrator set “No Output Design” as “Yes”, other persons are unable
to output the designs to the disk. If the user needs to output, he has to cancel “No
Output Design” first.
To use this function, the administrator password has to be set and it’s possible to
change this parameter after inputting the correct administrator password (refer to
10.7 machine management access).
To Next Page
Loading...
