DAHAO A88 - 11.2.3 Manual Operation of Sequin Embroidery

Chapter 10 Other Functions
140 BECS-A88/C88 computerized embroidery machine owner’s manual
applications parameter was managed by administrator recover to parameter value
that saved by administrator, the other parameters were initialized to default value
that saved by system.
10-8
Validation of factory ID
Note : BECS-C88 has this function, but BECS-A88 has not.
The factory ID is saved in the hardware of both control system and display system.
Meanwhile, factory ID are also contained in control system software and display
system software. When power-on, validation procedures run automatically in both
systems to test if factory IDs are matching. After that, system will test if the
factory ID of control system and display system are matching. System works
properly only when validation results are all positive, otherwise it will send out
error notices when machine is electrified. Related errors and their solutions are
listed below:
Error Description Cause Solution
FC:01 Operation software and
hardware is not consitent!
Operation software and
hardware
validation of
factory ID
is not consitent
Change operation system
software of certain factory
FC:02 Control software and
hardware is not consitent!
Control software and
hardware
validation of
factory ID
is not consitent
Change control system
software of certain factory
FC:03 Control system and
Operation system's factory ID is
not match!
Control system and
Operation system's
factory ID is not match
Change the software &
hardware factory IDs of
control system or operation
system
FC:04 Control system has
password!
Control system has
password and display
system has not password
Relieve control system
password or change operation
system
FC:05 Operation system has
password from C18!
Operation system has
b
een used and
password from C18
Change operation system
software
FC:06 Operation system Communicate connection Affirm connection is ok