DAHAO A88 - Chapter 4 Common Parameters and Color-Changing Order; Normal Parameters

Chapter 4 Common Parameters and Color-changing Order
48 BECS-A88/C88 computerized embroidery machine owner’s manual
Chapter 4 Common Parameters and Color-changing Order
In this system each design has its own settings of the normal parameters (like
scaling up/down and repetition) and color-changing order. When a new design is
selected, the corresponding settings of normal parameters and color-changing
order become effective.
This chapter is to introduce the settings of normal parameters and color-changing
order, which is entered by clicking
in the main screen.
This system supports multi-missions at the same time. So it’s possible to set or
change the normal parameters and color-changing order of non-current designs.
To do this click “More Functions” in the memory design management screen.
(See Chapter 6)
4-1
Normal Parameters
Normal parameters include: “X&Y Scales”, “Rotate”, “Direction”, “Prior Mode”,
“Rep. Mode”, “Rep. Prior”, “X&Y Reps” and “X&Y Interval”. The user can
control the final embroidery results by adjusting these parameters. That’s why
these parameters are often to be adjusted when a design is selected.
Enter the normal parameter setting screen by clicking
in the main screen.