Chapter 11 Sequin Embroidery
148 BECS-A88/C88 computerized embroidery machine owner’s manual
value is 3). We recommend that valve controlled sequin sending mechanism
uses the default value, while motor controlled ones use 4 to 5.
2. Practical Parameters of the Machine
(1) The speed limit of left (right) sequin device:
The speed limit depends on the sequin size. However, sewing the same sequin
with different mechanical structure, the acting angle could be different, which is
directly related to the maximum speed.
Note: the maximum speed of normal embroidery should be higher than the speed
limit of sequin embroidery.
(2) Automatic start or not:
When the setting is “Yes”, system will start embroidering sequin automatically.
When the setting is “No”, embroidery needs manually start.
(3) Sequin device automatically lift up in case of thread break
When the setting is “Yes”, system will lift up automatically in case of thread
break.
When the setting is “No”, the sequin device needs manually lifting the presser
foot.
11.2.2
Steps of Setting Sequin Parameters
See 5.1 General Setting of Parameters for Sequin Embroidery
11.2.3
Manual Operation of Sequin Embroidery
It has two ways of operation, centralized operation and separated operation.
1. Centralized Operation
To Next Page
