Chapter 11 Sequin Embroidery
BECS-A88/C88 computerized embroidery machine owner’s manual 147
4. Display working status separately
5. type of sequin sending and angle can be changed by operating on the control
panel.
C. Specifications
1. Sequin diameter range: 3mm to 9mm;
2. The maximum speed for sequin embroidery is 850 rpm.
11-2
Operating Sequin Embroidery
11.2.1
Direction of Sequin Parameters
Parameters of sequin embroidery are listed in appendix one. Here we explain some
of them as following.
1. Machine Parameters
(1) The left (right) sequin device: usually, sequin device is located in either first
needle position or the last (double sequin embroidery machine has sequin
devices on both the first and the last needle position). Users can set “Yes” or
“No”, which will activate or inactivate the particular sequin device.
(2) The acting angle of left (right) sequin device should be adjusted depending on
real status. Usually this parameter has been set during the manufacture
progress.
(3) Sequin sending angle of left (right) sequin device: it can be changed by
making adjustment to the angle of main shaft motor.
(4) Time needed for the sequin device’s going down: this parameter indicates the
time between device’s going down and the start of embroidering(0-15，default
To Next Page
Loading...
Need help?
General
