DAHAO A88 - Introduction of some Functions of General Parameters; Cyclic Embroidery

Chapter 5 Setting General Parameters
62 BECS-A88/C88 computerized embroidery machine owner’s manual
Click
to confirm and the system will save the result.
5-2
Introduction of Some Functions of General Parameters
There are brief introductions of the parameters in the appendix one. Here are
some functions used in embroidery.
5.2.1 Cyclic Embroidery
This function is to increase the embroidery productivity.
When the parameter“To Do Cyclic Emb.”is set as “Yes”, the cyclic embroidery
function is enabled and the icon
will appear in the main screen. When this
function is enabled, after completing the designated design the machine will
automatically embroider it again without pulling the bar.
Usually cyclic embroidery accompanies repetition embroidery and special
punched designs and the parameter “Auto Origin” should be also set as “Yes”.
Thus when the machine is embroidering the back embroidery cloth-piece, the
front one can be replaced. After embroidering the designated design, the frame
will automatically return to the start point and the machine will automatically