Chapter 11 Sequin Embroidery
BECS-A88/C88 computerized embroidery machine owner’s manual 151
11.2.4 Sequin Mending
After thread break or manually turning on the red lamp, pull bar and the
machine is in sequin mending. All the sequin devices will lift up; machine
stops when it backs to the stop embroidering point. Pull bar again to let the
sequin device (on mending head) down for mending. When it reaches the stop
point, machine stops, then other sequin devices will be down to continue
normal embroidery. Mending stitches in machine parameter setting is
ineffective in sequin mending.
11-3
How to Act Sequin Embroidery
Users should take the following steps:
1. Use sequin design. Design selection, changing and editing are required.
2. Set sequin parameters according to the above directions.
3. Check and adjust the sequin sending device to make sure it works normally.
4. Change the needle position to the sequin position. Make sure the sequin
control switch is in the middle and the blue lamp is on.
5. Pull bar to start embroidering.
11-4
Notice
During the process of embroidering, try to avoid touching the valve control
switch, or it may result in destroy of the sequin sending device.
To Next Page
Loading...
Need help?
General
