Chapter 9 Assistant Operation Functions
126 BECS-A88/C88 computerized embroidery machine owner’s manual
moving under B (b zone indicates the outside of stand), after thread break, press
the slow moving switch, frame will move back to B point. If no action, please
check the machine.
3. B point setting is as the image shows:
(1) If B point is above the line, then frame will back to B after slow moving.
There will be a long distance to go after threading.
(2) If B point is under the line, threading will be greatly influenced.
1. Frame 2. The desired line to set B point 3. Edge of the stand
To Next Page
