DAHAO A88 - Page 2

Index
II BECS-A88/C88 computerized embroidery machine owner’s manual
3-6 Folder Operation ........................................................................................ 44
3-7 Formatting a Disk.......................................................................................44
3-8 Deleting Objects in Disk (Including Design Files and Folders)................ 45
3-9 Creating a New Folder in the Current Folder ............................................46
Chapter 4 Common Parameters and Color-changing Order.................................. 48
4-1 Normal Parameters..................................................................................... 48
4.1.1 Setting “X&Y Scales”.......................................................................49
4.1.2 Setting of “Rotate” ............................................................................ 51
4.1.3 Setting of “Direction”........................................................................ 51
4.1.4 “Prior Mode”.....................................................................................51
4.1.5 “Rep. Mode”......................................................................................51
4.1.6 “Rep. Prior”.......................................................................................52
4.1.7 “X&Y Reps”...................................................................................... 52
4.1.8 “X&Y Interval”.................................................................................52
4-2 Setting of Color-changing order ................................................................ 53
4.2.1 Color-changing Screen...................................................................... 53
4.2.2 Setting of the color-changing order................................................... 54
4.2.3 Setting Needle Color......................................................................... 56
4.2.4 Interchanging of Needle Colors ........................................................57
Chapter 5 Setting General Parameters ...................................................................58
5-1 Setting Procedure for General Parameters................................................. 59
5-2 Introduction of Some Functions of General Parameters............................ 62