112 Magellan™ 3300HSI
Code 39 (continued)
Length Control
Fixed Length Decoding —
When fixed length decoding is enabled, the scanner will
decode a bar code if the label length matches one of the configurable fixed
lengths.
Variable Length Decoding —
When variable length decoding is enabled, the scanner
will decode a bar code if the label length falls in the range of the configurable
Length 1 and Length 2 values.
Code 39 Length 1, Length 2 Programming Instructions
See Length 1, Length 2 Programming Instructions on page 158 for detailed
instructions on setting this feature.
START / END
PROGRAMMING bar codes
Variable Length Decoding
DEFAULT
Fixed Length Decoding
NOTE
For Code 39 bar codes, all check, data and full
ASCII shift characters are included in the
length calculations. Start/Stop characters are
not included.
START / END
PROGRAMMING bar codes
DEFAULT SETTING FOR THIS FEATURE: 02
Set Length 1
Set Length 2
DEFAULT SETTING FOR THIS FEATURE: 50
To Next Page
Loading...
