Product Reference Guide 57
ACK NAK Options
This enables/disables the ability of the scanner to support the RS-232 ACK/
NAK protocol. When configured, the scanner and/or host sends an “ACK” when
it receives data properly, and sends “NAK” when the data is in error. Selections
for this option are:
•Disable
• Enable for label transmission — the scanner expects an ACK/NAK
response from the host when a label is sent
• Enable for host-command acknowledge — the scanner will respond with
ACK/NAK when the host sends a command
• Enable for label transmission and host-command acknowledge
START / END
PROGRAMMING bar codes
Disable ACK NAK
DEFAULT
Enable ACK NAK for Transmission
Enable ACK NAK for host command acknowledge
Enable ACK NAK for transmission and host command
To Next Page
Loading...
