Product Reference Guide 59
RS-232 Interface Features (continued)
Retry on ACK NAK Timeout
Enables/disables retry after the configurable ACK NAK Timeout Value (set in the
following feature) has expired.
ACK NAK Timeout Value
START / END
PROGRAMMING bar codes
Disable Retry on ACK NAK Timeout
Enable Retry on ACK NAK Timeout
DEFAULT
START / END
PROGRAMMING bar codes
This item specifies the time the scanner will wait for an ACK character from the host following a label
transmission.
00 = Infinite timeout
01 - 75 = Timeout in 200-millisecond increments
To configure this feature, scan the “START/END” bar code above to place the unit in Programming Mode,
then the “Set ACK NAK Timeout Value,” followed by the two digits (zero padded) from the Alphanumeric
table in Appendix C,
representing your desired value. Exit programming mode by again scanning the
“START/END” bar code above.
DEFAULT SETTING FOR THIS FEATURE: 01 (200 msec)
Set ACK NAK Timeout Value
To Next Page
Loading...
