62 Magellan™ 3300HSI
RS-232 Interface Features (continued)
Transmission Failure Indication
Enables/disables bad-label indication upon transmission failure.
Single Cable RS-232
Single Cable RS-232 Options
The RS-232 Single Cable interface shares some configuration options with
other RS-232 interfaces. Rather than repeat them in this section as Single Cable
options, please find them referenced as follows:
RS-232 Baud Rate on page -47
RS-232 Number of Data Bits on page -48
RS-232 Number of Stop Bits on page -48
RS-232 Parity on page -48
RS-232 Software Flow Control on page -51
RS-232 Beep on Not on File on page -56
RS-232 Label ID Control on page -80
START / END
PROGRAMMING bar codes
Disable Transmission Error Indication
Enable Transmission Error Indication
DEFAULT
To Next Page
Loading...
